terr

Active Member

• Feb 7, 2015

• #1

hello all again i have got to get 6 wires from the engine bay into the cab.
from the passengers/drivers side looking up cant see how to bring the wires in.
in the engine bay you have 2 big grommets wire loom but cant see them in side
do i need to start taking panels off(passengers glove box)
or is it easier to drill a new hole and put a grommet in itthanks
james

 

NeedleNose

Active Member

• Feb 7, 2015

• #2

On the passenger side behind the fuse box there is a large grommet - you might see a small nipple - chop it off and feed some stiffish wire like a straightened coat hanger through as a feeder. Tape the others to that and heavy away.

If you have aircon prepare to have grazed knuckles.

 

htr

Well-Known Member

• Feb 8, 2015

• #3

On the driver's side there is a large grommet high up behind that bonnet switch. Cut that 'nipple' off. I use a piece of curtain wire - stiff but flexible - to either pull wires through or hook wires with.

Inside, lie on your back on the driver' floor pan, look up to the base of the windscreen. You should see what ever you've poked through there.

 

gstuart

D3 Grandad

Full Member

• Feb 8, 2015

• #4

if yours in an auto there is a nice hole where the clutch pedal should be,

it's over an inch in size, can see it from under the bonnet and when u look under the dashboard there is some insulation that you have to cut to one side

if not what the other guys have said with regards to access

 

ZDomZ

New Member

• Feb 10, 2015

• #5

As has been said there are the big ones with nipples both sides. LR accessory wiring instructions say to use these in the way described above to feed wires through the bulkhead.