Hi,

We've come across a bit of a snag removing an engine from an ex military winterised LR.

It seems that the engine and gearbox are bonded together with some magical sealant that is resistant even to brute force and ignorance!

Does anyone have any knowledge about what these units are bonded together with and more importantly how to get them apart!!??
 
Dental floss is good at cutting through mastic seals.

But - you have got the nut off the input shaft, haven't you?

Edit. B*llocks, misread it, sorry. Thought you meant transfer box and gearbox stuck together.

Guessing that the shaft to clutch splines are rusty?

Sawing with dental floss tip works on mastic though. Best way to get the sump off an Alfa 156.
 
Last edited:
Boguig has simply observation. Engines n gearboxes ain't bonded together. It defies logic. There will be a simple engineering reason but not a bonding.
 
Don't know if these images help but they may shed some light somewhere. Its a '83 ex mil 109.










Once I had released all the bolts then it dropped off after a clout with a rubber mallet.
 
Boguig has simply observation. Engines n gearboxes ain't bonded together. It defies logic. There will be a simple engineering reason but not a bonding.
Can you elaborate? This has been sealed everywhere, I'm passing on 2nd hand information from the chap that's doing the work for me (and no I'm not paying him, so he's no reason to steer me the wrong way) :)
 
Sounds lik a job for brute force and ignorance, unless there is still a bell housing bolt in place!
 
Are all the nuts off? Its possible you could have missed one. Also a stanley blade can be used to remove mastic. For a brute force approach use a fox wedge between tge engine and gearbox to get them apart
 
If you are really sure all the nuts are off then start trying to spray the clutch splines. Maybe a piece of screen jet tube on a squeezy washing up bottle,
the clutch plate will be knackered anyway and that is all that can hold it on.
 
Maybe glooped full of silicone to stop leaks or whatever ....

The dental floss approach will not work because of the studs left in...but may help to get through some of silicon if it's there ...
A slow and steady approach may be best ...
 
Boguig has simply observation. Engines n gearboxes ain't bonded together. It defies logic. There will be a simple engineering reason but not a bonding.
series engines and boxes are a spigot fit they do corrode fast, its often wise to use the clutch so break the hold before fully stripping the units out
 

Similar threads