B

belly257

Member
I have a 1994 200tdi one of the last. It needs a crank seal and the gearbox is qbit tight and has a little crunch and makes noises when im revving it hard off road. So when I pull the box out whats best another lt77 box or the later r380? I don' do loads of road miles but do do alot of off roading
 
I will be when mine gives up, had my lt77 rebuilt a few years ago due to lack of v8 r380 boxes but wish I'd searched harder!
 
I am now changing my box for r380 on my 92 discovery have just bought complete gearbox and transfer box from a 95 300tdi fitting over the weekend also bought the 300 gearbox crossmember as i noticed the mounts are set further outboard should keep everything steadier i will let you know how it goes
 
tyregeezer said:
I am now changing my box for r380 on my 92 discovery have just bought complete gearbox and transfer box from a 95 300tdi fitting over the weekend also bought the 300 gearbox crossmember as i noticed the mounts are set further outboard should keep everything steadier i will let you know how it goes
Click to expand...

So you say the 2 mounts on the crossmember are slightly further apart? May have to get a crossmember to lol
 
looking at the 200 and 300 gearbox crossmember they are the same width, the crossmember to chassis mounting holes line up apart from one so the original mounts on the 300 gearbox should match the 300 crossmember. on the 200tdi the rubber mounts are underneath the boxes and quite close together. on the 300 the rubber mounts are wider apart almost out to the chassis i i hope this will stop a little of the rock n roll my only worry is exhaust clearance i'll let you know how i get on i now have the parts and will start sometime over weekend
 
Last edited:
tyregeezer said:
looking at the 200 and 300 gearbox crossmember they are the same width, the crossmember to chassis mounting holes line up apart from one so the original mounts on the 300 gearbox should match the 300 crossmember. on the 200tdi the rubber mounts are underneath the boxes and quite close together. on the 300 the rubber mounts are wider apart almost out to the chassis i i hope this will stop a little of the rock n roll my only worry is prop clearance i'll let you know how i get on i now have the parts and will start sometime over weekend
Click to expand...
cross member does indeed bolt to old mount holes and also uses some of 200 chassis cross member holes
 
You must log in or register to reply here.

Similar threads

B
Making my 1994 200tdi reliable
Replies
18
Views
1K
D1Nut
D1Nut
dag019
A question of gearboxes
Replies
16
Views
935
Skolmate
Skolmate
E
LT77 REVERSE GEAR DOESN'T WORK
Replies
3
Views
211
tottot
tottot
E
Auto gearbox woes
Replies
3
Views
739
sierrafery
sierrafery
G
Land Rover 300tdi clutch not disengaging after engine out
Replies
6
Views
694
Geckomike
G