Bobsticle
De Villes Advocaat
I am a Doctor
border
Well-Known Member
Found the kit but it is for SWB, will also have to check if my manifold has 3 or 4 holes, Exhaust Fitting Kit - RHD - Paddock Spares
Turboman
Mab An Gov
Philosophy or Divinity?I am a Doctor
Bobsticle
De Villes Advocaat
You may only need the copper gasket. The rest should come with the exhaust.
Even then the gasket won’t go on a crush pipe. These just pull onto the manifold and seal on the rounded end of the exhaust.
Have a look if your manifold has a rounded recess where the pipe sits.
Turboman
Mab An Gov
I think there is a hearing loss issue with Series in general.
I don't much care, I am half deaf already. More worried about my back, and my sciatica!
border
Well-Known Member
Will have to check it tomorrow, think it is rounded though
Turboman
Mab An Gov
3 bolt on that one. Use plenty of exhaust paste. Eases assembly, and makes sealing up more likely.
Bobsticle
De Villes Advocaat
I seem to remember the four hole flavour are a side fitting. The three hole are bottom fitting like the diagram on the paddocks site.
Oh and I also used a smear of paste on the joints.
Bobsticle
De Villes Advocaat
Yea. It looks like the standard three stud bottom fitment.
border
Well-Known Member
Yes think so to, have emailed them to see if brackets ect are included, or might try and find one somewhere else that does include them.
border
Well-Known Member
See the top bit on this pic,
Attachments
border
Well-Known Member
Think it is Mate, I put about 7 litres of oil in and its showing right on the mark on stick.Oh, and make sure that dip stick tube is tight down.
1/4 inch high and the oil measures wrong.
Bobsticle
De Villes Advocaat
Cool. Mine had a copper washer so had to be wound right down to the block.
border
Well-Known Member
Paddocks don't seem to sure as to which will fit from these Land Rover Series 2, 2A and Series 3 - 109 inch Mild Steel Full Exhaust Systems - Paddock Spares If they don't know I aint got a clue
border
Well-Known Member
Under seat
