williamadam said:

I have 2.5dt range rover Rover when I change the gear the car is off unless I remove my feet from the break and press the pedal and then change the gear from P to R, or from N to D.
Please, any advice or recommendation.

Click to expand...

Datatek said:

Don't understand your message, but the auto will normally move off when a gear is selected if you do not have your foot on the brake.

Click to expand...

williamadam said:

Thank for your replay, what I mean that I switch the car on and press on the break and then change the gear from P to R , then the car switch off.

Click to expand...

williamadam said:

yes, you are quite right again dear Wammers.

Click to expand...

wammers said:

If from a cold start the engine speed is 1100 RPM or so then drops to 750 RPM after a couple of minutes the idle control/cold start fuel is ok. If the engine is idling at 750 RPM and when you engage gear it stops, you have a problem with the injection pump quantity servo. You will need a replacement injection pump. You may be able to put this off for a time by increasing idle to 800 RPM or so with a Nanocom.

Click to expand...

williamadam said:

Thank you for replay, its 800 RPM idling, sorry what do mean a Nanocom?

Click to expand...

williamadam said:

Thank you for replay, its 800 RPM idling, sorry what do mean a Nanocom?

Click to expand...

Grrrrrr said:

Sounds like someone already adjusted the idle speed.

Click to expand...