1.Put the car into gear and apply the hand brake, loosen front wheel nuts, raise vehicle on a jack and then support the front axle on axle stands.
2.Remove the front wheels.
3.Bolt the wheel spacer/ adaptor to the hub using the new wheel nuts supplied and torque the nuts to 130Nm or 96lb/ft.
4.When both sides are done fit the new wheels lower the car off of the axle stands and torque the wheel nuts to 140Nm or 103lb/ft.
5.Loosen rearwheel nuts, raise vehicle on ajack and then support the rearaxle on axle stands.
6.Remove the rearwheels.
7.Bolt the wheel spacer/ adaptorto the hub using the new wheel nuts supplied and torque the nuts to 130Nm or 96lb/ft.
8.When both sides are done refit wheels lower the car offof the axle stands and torque the wheel nuts to 140Nm or 103lb/ft.