Hi Guys....

2008, Disco 3, HSE, TDV6, Auto with Air Suspension

Does anyone have the LR spec's for the Wheel alignment (Front & Rear) ?

Had the wheel alignment done on a 4 Wheel, Hunter setup last week and the following figures were given after adjustments, which were done in Tight Tolerance Mode.

The car is drifting slightly to the left and the steering wheel position is very slightly biased to the right when driving on a straight road. Tyre pressures are set for normal use and there is a full tank of fuel.

The rear suspension has been completely renewed including, bushes,ball joints, toe rods and wheel bearings. The front suspension has had the wheel bearings and track rod ends replaced- the upper and lower ball joints are good.

Front Toe 0 deg 22' (Total) Rear Toe -0 deg 09' (Total)

The car is going back there tomorrow for another check.

Before the car was taken in, the steering followed a straight line and the steering wheel was in the straight ahead position.

I think they're in haynes manual. I can have a look tonight but I don't finish work til 11

I have a Haynes manual and they state "With an unladen vehicle, full tank and at normal height" Air Suspension: :

Front Toe 10' Plus/Minus 12' (Total) Rear Toe 14' Plus/Minus 8' (Total)

My LR Handbook gives,-no mention of Tight Tolerance Mode or ride height etc.:
IMPERIAL
Front Toe -(Minus) 0.10' Plus/Minus 12' (Total) Rear Toe 10' Plus/Minus 12' (Total)
OR
METRIC
Front Toe -(Minus) 0.16 Plus/Minus 0.2 Deg. (Total) Rear Toe 0.16 Plus/Minus 0.2 Deg. (Total)

Hope this helps

Thanks for your reply