According to the trip computer I get 22mpg in my derv. Is all up hill round here so you're constantly WoT.
 
Currently averaging around 19mpg - L322 4.4V8 (BMW) - that is according to the trip computer though

P38 2.5DT manual was 25mpg generally, 28 on a long run...


Cheers,

Jerry
 
l322 td6 around town between 22 to 24 mpg went to norfolk last sunday sat a consdent speed and manged 30.1mpg couldnt beleive it !!!!! cheers mike
 
I am getting about 14.7mpg on a 1995 4.6 hse but I just reset the ecu and sorting out a few electrical bugs and the tyre pressures should hopefully improve matters. It just bowled over to birmingham and back on under half a tank of fuel at motorway speeds but the short trips to the stables and back tend to pull the figure down again. Still, paid 1500 quid for it and it is rock solid so I can't complain in overall terms.
 
On a related note, my rangie is currently wearing 16 inch alloys with stock size tyres. Does anyone know if switching to a set of 18 inch tornados or similar would improve the mpg any? I am wondering if there is a rolling resistance issue in play? I will also redex the engine and change out the fluids again, but the next job is brake pads...
 
On a related note, my rangie is currently wearing 16 inch alloys with stock size tyres. Does anyone know if switching to a set of 18 inch tornados or similar would improve the mpg any? I am wondering if there is a rolling resistance issue in play? I will also redex the engine and change out the fluids again, but the next job is brake pads...
Will make no difference to MPG...rolling resistance will be exactly the same....

on 18's the P38 is a little wondery...have to get the tyre pressures spot on for a decent ride on 18's
 
Average 25mpg from my TDV8 on mixed driving round town and A roads. have been close to 35mpg on a steady long run at 60
 
On a related note, my rangie is currently wearing 16 inch alloys with stock size tyres. Does anyone know if switching to a set of 18 inch tornados or similar would improve the mpg any? I am wondering if there is a rolling resistance issue in play? I will also redex the engine and change out the fluids again, but the next job is brake pads...

Made no difference to me (maybe 20 miles more per tank) switching from 20's to 16's.

On my A3 TDI I gained 50 miles per tank switching from 18's to 16's.

Basically, smaller wheels are generally lighter and thinner, so less road resistance, and less weight so better fuel economy.
 
Made no difference to me (maybe 20 miles more per tank) switching from 20's to 16's.

On my A3 TDI I gained 50 miles per tank switching from 18's to 16's.

Basically, smaller wheels are generally lighter and thinner, so less road resistance, and less weight so better fuel economy.
Got feck all to do with resistance....unless they are of narrower width...then there will be a small reduction in resistance...but if maintaining same width and similar tread pattern and depth, there will be no difference in rolling friction....

You could argue Polar and Mass moments of inertia and etc, but can't be arsed gooooooogle it! :D
 
Last edited:
I did actually say they were generally lighter and thinner (meaning width), so yes, less resistance. Smaller diameter wheels are generally narrower than larger diameter wheels, albeit not always.

I have a degree in Physics, don't really need to google that. Cheers.
 
I did actually say they were generally lighter and thinner (meaning width), so yes, less resistance. Smaller diameter wheels are generally narrower than larger diameter wheels, albeit not always.

I have a degree in Physics, don't really need to google that. Cheers.
And my Masters was in Aeronautical and Aerospace Design Engineering so I don't need to goooooogle it either :D
 
I did actually say they were generally lighter and thinner (meaning width), so yes, less resistance. Smaller diameter wheels are generally narrower than larger diameter wheels, albeit not always.

I have a degree in Physics, don't really need to google that. Cheers.
But the tyre carcass tends to weigh more than the extra material required to make larger alloys. So it is twix and tweens. What makes most difference is correct tyre pressure. Changing wheel size was academic, I suspect you actually had the correct pressures for once.
 

Similar threads