BuzzLand

Active Member

• Apr 2, 2017

• #1

My lannie (300TD) has been stood a while and water pooled on the roof a bit.
It's caused over time the paintwork to flake away.

So I need advise on which is the best paint to get, I fear that 'cause it is a aluminium roof I'll need special stuff / primers etc.
Thanks

 

Last edited: Apr 2, 2017

Foxyred

Well-Known Member

• Apr 2, 2017

• #2

Sand back, Etch primer bare metal, then normal paint

 

mick the builder

Well-Known Member

• Apr 2, 2017

• #3

Rub it down, use etch primer if you go down to metal. You can use ordinary primer on top of that if you want then spray top coat.

 

BuzzLand

Active Member

• Apr 2, 2017

• #4

Thanks, I'll do that. When it comes to the water pooling I'll just get some ramps under it.

 

Alan Crossley

Well-Known Member

• Apr 2, 2017

• #5

BuzzLand said:

Thanks, I'll do that. When it comes to the water pooling I'll just get some ramps under it.

Click to expand...

Is the water coming into the vehicle through the roof ?

 

BuzzLand

Active Member

• Apr 2, 2017

• #6

Alan Crossley said:

Is the water coming into the vehicle through the roof ?

Click to expand...

No, but it is pooling on the roof a bit when it rains.

 

M

Muddy Vicky

Member

• Apr 2, 2017

• #7

As well as the etching primer, I'd then use a filler primer before the top coat, it'll help fill in any imperfections where in time the etching primer may flex away and allow water to get underneath again as well as allowing you to flat sand easier before the top coat. Do you know what top coat you're going to use as that could affect your choice of etching primer?

 

mick the builder

Well-Known Member

• Apr 3, 2017

• #8

Has the support bars underneath bent, if so could you push them back into place or put wedges in between?

 

L

lynall

Well-Known Member

Full Member

• Apr 3, 2017

• #9

Remember to paint it white otherwise you will cook in standing traffic come summer time.

 

P

philsefo

Active Member

• Apr 4, 2017

• #10

I recently painted mine, the roof was dinted in slightly, managed to pop it out and fill some of dints with filler. Then just etch- high build then white spray can from wilko. Rustoleum brand I think. It worked well

 

D

David g4yvm

Active Member

• Apr 4, 2017

• #11

Good thread...answered my own questions too

D