Needs to be done,
New rear door,
Rear diff propshaft seals,
Replace rusty wheels

Would like to do
LED lights
Limited slip diff
More sound proofing
Refit cab I which is very tatty, with
New door trim,
Centre console,
New seats,
Roof console.
Cb and radio.
 
Not much at the moment:

Front diff pinion seal (slight weep)
Service injectors (no issues but probably due for it)
Fix heater vent flap mechanism in lower dash
 
Buy and fit

a rear brake pipe T piece

a rear flexi brake pipe not decided which one i need yet def or disco

a rear axle prop drive flang kit ( 4 bolt one )

a couple of copper brake pipes to the rear axle

ready for swapping the disco 300tdi rear axle over onto my 90 in a couple of weeks.

then buy and fit a plus 2" lift kit ( terraferma )

then in the new year buy and fit a recon'd gearbox with a 1.2 transferbox then later on in the new year buy a new galv chassis and start swapping everything over :D
 
Buy and fit

a rear brake pipe T piece

a rear flexi brake pipe not decided which one i need yet def or disco

a rear axle prop drive flang kit ( 4 bolt one )

a couple of copper brake pipes to the rear axle

ready for swapping the disco 300tdi rear axle over onto my 90 in a couple of weeks.

then buy and fit a plus 2" lift kit ( terraferma )

then in the new year buy and fit a recon'd gearbox with a 1.2 transferbox then later on in the new year buy a new galv chassis and start swapping everything over :D

I'd get 2" extended hoses then if you're lifting. That's what I've done as getting the lift put on tomorrow. It's in the local workshop back home having:

Springs + shocks
Extended brake lines
Timing belt
Tensioner
Water pump (might as well whilst it's all off)
 
My defender needs prepping for its MOT next week, 50/50 whether it'll pass.

My series 2a needs prepping for selling, its time for it to go i think, got a new Glavo chassis with it, but just dont have the time :/
 
My defender needs prepping for its MOT next week, 50/50 whether it'll pass.

My series 2a needs prepping for selling, its time for it to go i think, got a new Glavo chassis with it, but just dont have the time :/

Make sure yer fog light works, I keep forgetting to check it! The terminal on it often gets water and corrodes stopping it from working.
 
Nothing NEEDS doing but I've loads of stuff to do through choice

Replace headlights and rewire (already purchased)
But lights for light bar and wire (already have the bar)
Work out how to instal snorkel
Finish off soundproofing the inside
Finish putting dash back together
etc, etc, etc :)
 
Done the seat and scrapers now just need to:

Give it a service, change the antifreeze ready for winter and re glue my rear headlining, and fit the plastic lining in the inner doors properly to stop them leaking.
 

Similar threads