made up and fitted rear window trim sides and wheel boxs . cost about 30 quid all in .
 

Attachments

  • IMG_1150.jpg
    IMG_1150.jpg
    231.7 KB · Views: 218
  • IMG_1153.jpg
    IMG_1153.jpg
    226.2 KB · Views: 219
  • IMG_1155.jpg
    IMG_1155.jpg
    222.4 KB · Views: 226
made a template out of card board, transfered it and cut it out of 4mm ply, bought a 8x4 sheet fibre board and cut same. stuck the two together with impact adhesive. cut and stuck 1/4 inch foam around window so when i glued the board on , as you pushed, it compressed the foam at high spots that way it stuck all over. bought a remnant from local car trimmers stuck it on using impact adhesive ( carpet fitters contact spray in a can, not ordinary spray glue this is not up to it and goes manky )then sprayed the back of the board and the foam and carefully put it in place.same for all the other bits.
 
I think I've successfully replaced my lift pump.

Well, it started and didn't squirt any fuel or oil - better than before so far ;)



Just not sure how tight I should have tightened the bolts.

Manual gave a torque setting (25Nm) but there's no way I could get my torque wrench anywhere near. In fact because it was so fiddly I ended up using a screwdriver handle with an extension and then my socket......
 
cleaned up all the fuses and connections and got the heater working for the first time!:)
Also got low fuel warning light working - lifted floor and it was unplugged from sensor. Hope all jobs are going to be this easy!
 
Ran over a rabbit:eek: (no not intentional ... I ain't BoB), it got it's revenge when one of it's bones punctured the tyre, chance in a fckin million as it's gone straight through the tread into the tyre:doh: ... crossed finger's that the tyre ain't knackered as there's lot's of tread left on it.
 
Removed the steering box and front axle from my scrap Disco 1.
Also drained a couple of gallons of diesel out of it which was a bonous:D

Might fit the steering box on the 110 if that one's leaking. Wasn't dripping if I remember so maybe keep it for a spare.:)
 
Broken it again :(

Turned off the motorway and lost all power steering. Hopefully just the belt slipping, new one on it's way and then we'll see !!
 
You must log in or register to reply here.

Similar threads

B
defender 2.4 puma reverse light switch
Replies
4
Views
654
BEASTIE 90
B
Padda.116
300tdi disco 1, new head gasket oil leak!!
Replies
10
Views
797
Padda.116
Padda.116
Knappster
Shot-blasting steel wheels
Replies
9
Views
1K
Knappster
Knappster
B
Discovery Sport Need some advice please
Replies
2
Views
296
Bp112
B
F
Freelander 1 Tank lift pump: '06 TD4... maybe ok?
Replies
4
Views
240
freelounger
F