Used it to pick up some feed for the animals, bout it. Tried to replace the carb kit on my old quad, dam thing won't start now unless I squirt fuel into the air intake. Don't suppose anyone know anything about small carburetors?
:(
 
Used it to pick up some feed for the animals, bout it. Tried to replace the carb kit on my old quad, dam thing won't start now unless I squirt fuel into the air intake. Don't suppose anyone know anything about small carburetors?
:(

picture please.
 
you did turn the petrol on?

Haha yes, I did turn the petrol on. I don't know too much about them but I don't think the bowl was filling up with fuel, not sucking any thru? there was fuel in the fuel lines to it, it just didn't seem to want any :/
 
Yep, he's called tony and is a complete bellend! No one likes him but he has connections as all annoying c*nts do…….
<br />
<br />
Oh yes, I have one of those too, member of the dodgy handshake brigade allegedly, think thats why the coppers didnt show at his house one night after I reported something that was going on there.<br />
Upset him no end when I chainsawed half of the hedge between us, so his just looks stupid now sat there waving around lol.<br />
<br />
Best solution for bellends... builder's foam, long bit of hosepipe, up the exhaust as far as you can, good ol' squirt of the foam, remove all evidence, garage job to locate problem :violent:
Sneak round, lift alumium lid/manhole cover back of house n ram a couple of bricks up. No time at all overflowing with crap
 
Fitted a rear output seal on me transferbox with the aid of Pikeys patented seal presser innerer :D

Actually got a handbrake that works so I might spend the evening parking on a varity of hills :p
 
Ere pikey.
Let me know wot that is please. Gotta do the same tomoz.

Twas a 2" bath plug fitting on about 18" of copper pipe, exact right dia and long enough to go through the crossmember so I could tap it home with a hammer nice and square :)

He took a piccy which I imagine will turn up at some point soon. Expect a post in the 'spammin bastids' fred offering a (derisery) discount to members :D
 
Sorted pipes out on egr solenoid and found out where the spare air pipe went it was for cruise control solenoid the 1 tucked away nr headlight :d
 
It's a lot biggern 2"dia. I use a large wheel bearing outer race over the seal and use the old nut on the shaft to wind it in.
 
Fitted some Grabber ATs, got it wet at billing, doors stayed on :eek:

GrabberAT.jpg


Splash.jpg


1st of many of this type of fun in my landy I hope!
 

Similar threads