Well I fitted a full set of air bags to the old girl, as I'm sick and tired of the car dropping down. And boy were they shot most of the rubber was flaking off, you could rub it of with your thumb and then see the fibers. Not to bad did the fronts in about 40 min's the rest of the 3 hours was doing the back's. The car now seems OK until I measured the height's, found the back to be spot on at 470 mm but the front now at 500 mm so 30mm to height. Tried to do a reset on the front though the laptop, but every time I got it down to the right height it told me incorrect ride heights, so I've just left it alone for now.
I will let it settle then have another go a lowering the front, that will be tomorrow let's hope I can get this sorted.
 
Last edited:
J L Carr said:
Well I fitted a full set of air bags to the old girl, as I'm sick and tired of the car dropping down. And boy were they shot most of the rubber was flaking off, you could rub it of with your thumb and then see the fibers. Not to bad did the fronts in about 40 min's the rest of the 3 hours was doing the back's. The car now seems OK until I measured the height's, found the back to be spot on at 470 mm but the front now at 500 mm so 30mm to height. Tried to do a reset on the front though the laptop, but every time I got it down to the right height it told me incorrect ride heights, so I've just left it alone for now.
I will let it settle then have another go a lowering the front, that will be tomorrow let's hope I can get this sorted.
Click to expand...
Changing the airbags should not have affected the heights as that is controlled by the height sensors. I suppose you left the tailgate or a door open when jacking to freeze the suspension? Maybe the sensors have picked up some crap being extended past their normal range.
Only adjust in very small steps or, as you found, you will go out of range and the EAS will revert to default settings.
 
Tried to remix the drivers door card. Bought the car a week ago found someone had tried to fix card with Silicon sealant and a couple of holes drilled in foam under side pocket.
Can I get new card lugs for card? Bought the little black serrated slip on pins. But half the lugs are missing/snapped off.
 
Gadgetdave said:
Tried to remix the drivers door card. Bought the car a week ago found someone had tried to fix card with Silicon sealant and a couple of holes drilled in foam under side pocket.
Can I get new card lugs for card? Bought the little black serrated slip on pins. But half the lugs are missing/snapped off.
Click to expand...
Yes you can buy the card lugs if you mean the plastic pins. Try Ebay.
 
Replaced the Vinyl on the quarter panels on the classic
ukadamwest-albums-classic-picture16095t-20140909-121824.jpg


*Note to self: Dont pick nose with contact adhesive on fingers.

P38's still faultless (touch wood)
 
You must log in or register to reply here.

Similar threads

A
Range Rover L322 - not turning over
Replies
11
Views
779
brasso
brasso
B
L320 range rover sport 3.0 tdv6 loosing power steering fluid
Replies
3
Views
400
Mark Piercy
Mark Piercy
F
1980 Range Rover 2 door v8 to 300tdi
2
Replies
20
Views
1K
Grrrrrr
Grrrrrr
T
Non start
Replies
3
Views
691
Datatek
Datatek
T
Fan Clutch??
Replies
14
Views
739
Grrrrrr
Grrrrrr