Cleared debris from the diaphragm in the eas block... 
doriz
Well-Known Member
Disgraceful behaviour
Salisbury Nick
Well-Known Member
Replaced the entire EAS valve block - the whole box, block, pump and the box itself all in one go.
Reduced the faults from about 20 - including all the sensors being incorrect, the exhaust valve being jammed open, and jammed shut, and some other valve jammed open - and shut - and the vehicle having moved!
Now there are only two faults and one of those is 'vehicle has moved' - though it had not!
Reduced the faults from about 20 - including all the sensors being incorrect, the exhaust valve being jammed open, and jammed shut, and some other valve jammed open - and shut - and the vehicle having moved!
Now there are only two faults and one of those is 'vehicle has moved' - though it had not!
It can fork oft!!
doriz
Well-Known Member
Can’t you push it next door and set it on fire?It can fork oft!!
Have you ever pushed a RR?
doriz
Well-Known Member
Have you ever pushed a RR?
Googs
Member
Checked all the air suspensions height levels on the L322 today with my All Comms....found that they were out so i got some masking tape out an put on each centre of wheel and measured to top of wheel arch and double checked then re-written them into the All Comms and locked them in. I'm guessing that who ever owned the L322 before me didn't care less what measurements were in the program and more to the point how it looked as a level vehicle or how it performed. but all good now.
Henry_b
Think outside, no box required.
Yep..Have you ever pushed a RR?
Once. Thats why I have a herniaHave you ever pushed a RR?
Vehicle has moved is not a fault but default position on startup.
Datatek
Well-Known Member
Vehicle has moved always comes up if there has been any suspension adjustment after the ignition has been turned off, it can be ignored. What is the other fault? The long list of faults usually means bad comms.
Datatek
Well-Known Member
Not so, it means there has been a suspension adjustment after the ignition was turned off.
Scotiawhiskers
Well-Known Member
Only downhill. I'm not (that) stupid.Have you ever pushed a RR?
Salisbury Nick
Well-Known Member
I think it was related to one of the sensors reading incorrectly.
Cleared the airbag light.....again
Fixed the rear wiper.........again
Topped up the screen wash.........again
Fixed the rear wiper.........again
Topped up the screen wash.........again
doriz
Well-Known Member
How did you clear the airbag light. There was a period mine would come on for about 10 mins every time I went someone before clearing itself. Now I notice it’s stopped coming on.Cleared the airbag light.....again
Fixed the rear wiper.........again
Topped up the screen wash.........again
Besides that I ordered a new dog light bulb.
