payydg

payydg

Well-Known Member
Its the rear hub seal for the rear axel for a 1991 200tdi defender 90.

Ordered a couple of different ones and non of them seem to look like the one thats in the hub.

Any help greatly appreciated
 
ftc4785 is a grease seal it has no garter spring and is for hubs with grease,rtc3511 is an oil seal it is used for hubs using oil
 
jamesmartin said:
ftc4785 is a grease seal it has no garter spring and is for hubs with grease,rtc3511 is an oil seal it is used for hubs using oil
Click to expand...

The axel uses EP90 so i guess it would be the RTC3511 but just looks totally different to the one that I've taken out
 
How do you guys set the wheel bearing pre load. I seem to remember the last time I did it I just took the play out of the bearings by tightening the nut by hand - I.e holding the big socket and turning it by hand not using a wrench.
 
payydg said:
How do you guys set the wheel bearing pre load. I seem to remember the last time I did it I just took the play out of the bearings by tightening the nut by hand - I.e holding the big socket and turning it by hand not using a wrench.
Click to expand...
yes just remove all play then fit tab washer and other nut tightening the outer nut applies enough preload
 
You must log in or register to reply here.

Similar threads

L
LR 90 Engine to flywheel housing gasket?
Replies
2
Views
448
lasher99
L
dag019
Which stub axle seal do I need?
Replies
3
Views
528
tottot
tottot
jimllshiftit
Any advice for novice welder about to stitch new rear cross member to 90 chassis?
Replies
3
Views
324
tottot
tottot
jimllshiftit
Can anyone identify what these chassis' are, please?
Replies
16
Views
1K
Brown
Brown
meego
What Rear Lights Do I Need ?
2
Replies
30
Views
1K
meego
meego