H

Hambo44

Member

• Sep 10, 2015

• #1

Hi All,

I have an issue, the exhaust manifold has warped, and snapped off three studs. Two at the front and one at the rear. I have tried to get them out but they are very stuck, plus the air con pump is in the way of the front two so I cant access them easily. Any help or advice is welcome.

Thanks,
Jonathan.

 

jamesmartin

Well-Known Member

• Sep 10, 2015

• #2

you can move aircon pump even with it still piped up
this type of stud extractor i find the best
http://www.google.co.uk/imgres?imgu...d=0CCEQMygBMAFqFQoTCMGkyeuA7ccCFc4p2wodPs8BpA

 

Marmaduke

Well-Known Member

• Sep 10, 2015

• #3

Has it snapped them off flush with the head or is anything you can get at?

 

freelance

Well-Known Member

• Sep 10, 2015

• #4

Yep, got those stud extractors by stahwile, excellent bit of kit!

 

L

lynall

Well-Known Member

Full Member

• Sep 11, 2015

• #5

When you get the manifold off it will ned refacing and also the webs cutting out, this allows more flex and stop's the warp happening again.

 

H

Hambo44

Member

• Sep 14, 2015

• #6

Thanks for the replies!

jamesmartin said:

you can move aircon pump even with it still piped up
this type of stud extractor i find the best
http://www.google.co.uk/imgres?imgurl=https://cdn2.ridgid.com/resources/media%3Fkey%3D9c3e5a5b-14c5-4335-914b-e15ef2fc87ee%26languageCode%3Den%26countryCode%3DUS%26type%3Dimage&imgrefurl=https://www.ridgid.com/us/en/screw-extractor&h=938&w=1000&tbnid=yCz173sw4WKmkM:&docid=B9y8-M4JrWLZTM&ei=1r_xVcHhDM7T7Aa-noegCg&tbm=isch&ved=0CCEQMygBMAFqFQoTCMGkyeuA7ccCFc4p2wodPs8BpA

Click to expand...

Looks like a good bit of kit. I have a similar one,

Marmaduke said:

Has it snapped them off flush with the head or is anything you can get at?

Click to expand...

Yea they have snapped flush. Wouldn't have been a problem otherwise.

lynall said:

When you get the manifold off it will ned refacing and also the webs cutting out, this allows more flex and stop's the warp happening again.

Click to expand...

It has been faced, and I will cut the webs out before it goes back on.

Thanks,
Jonathan.

 

L

lynall

Well-Known Member

Full Member

• Sep 15, 2015

• #7

I did use some fancy nut's when I did mine as they had built in floaty type washer's so allowed more movement, sorry cannot remember what they came off ?
Also drilled all holes bar the most end two out another couple of millimetres again to allow movement.