O

Otto

New Member

• Jul 9, 2009

• #1

Hello group, my R Registered 110 has started vibrating quite severely recently. I noticed a strange noise coming from underneath last weekend, it was like consistant knocking, yesterday when I went to work the 110 was vibrating when I got to 50-60MPH, so much so that it rattled one of the starter motor connections off. I can't see any visible signs of damage or wear, I did have the clutch replaced about a month ago, could this be suspect.
Any help would be gratefully accepted as I'm hoping to sell next week and upgrade to a newer model, but I would'nt sell knowing it had a fault.
Regards
Otto

 

DEF49

Active Member

• Jul 9, 2009

• #2

Sounds like yer rear prop is falling off

 

Shifty1962

Well-Known Member

• Jul 9, 2009

• #3

My guess is propshaft Ujs.

 

ratty

I'm not special I'm limited edition

• Jul 9, 2009

• #4

Shifty1962 said:

My guess is propshaft Ujs.

Click to expand...

prop u/j's or wheel bearing. Judging by the noises u'j's.

 

O

Otto

New Member

• Jul 9, 2009

• #5

Thanks for the replies, I used the car for work today and the noise has increased to a high pitch when under load i.e When accelerating, vibrating quite a lot. Had the UJ replaced on the transfer box about a month ago. I replaced the rear oil seals last week on the 110 and noticed the bearings were in very good condition, packed them with grease and refitted them so I'd like to rule these out. I think my initial thought regarding the clutch may have been unfounded and I'm thinking that it may be one of the front wheel bearings going, is there an easy way to determine which one it could be, ie jacking up the car and rolling the wheels?
Any advice appreciated

 

Tervueren

New Member

• Jul 9, 2009

• #6

Just grab the wheel top and bottom and feel for any movement, may also be worth checking your engine mounts seeing as you say it does it under acceleration.

 

O

Otto

New Member

• Jul 10, 2009

• #7

Thanks for the comments guys. Got under the 110 today, the UJ on the front propshaft is shot. Can anyone supply me with one of these sharpish?
Regards
Dennis

 

ratty

I'm not special I'm limited edition

• Jul 11, 2009

• #8

Otto said:

Thanks for the comments guys. Got under the 110 today, the UJ on the front propshaft is shot. Can anyone supply me with one of these sharpish?
Regards
Dennis

Click to expand...

Do you have a local landrover independent near you or a parts dealer? If not you could use paddock spares, john craddocks etc online or pm iannotts on here. He runs axletwister 4x4.

 

O

Otto

New Member

• Jul 11, 2009

• #9

Thanks ratty, I'll give Ian a tinkle.
Regards
Otto