D

diko93

Active Member

• Jan 22, 2014

• #1

Im converting a truck cab 90 to a van I have the sides roof and back door is there some special mounts to bolt the sides on or is it just normal holts and washers cheers andy

 

Jonnyb1990

Well-Known Member

• Jan 22, 2014

• #2

My csw is riveted as far as I can see, and a few welds(unsure which type)

Hope that helps

 

Southernlandy

Active Member

• Jan 22, 2014

• #3

My car was originally a pick up but was converted, hopefully this picture should help you. Mine hasn't got a back door but has a tailgate with a series catflap on the top

 

mlucas110

New Member

• Jan 22, 2014

• #4

Just the usual bolts and holdings mine had one on corners and ends, few extra by doors and one on the inside of the tub

 

Davv

New Member

• Jan 22, 2014

• #5

theres a foam seal that sits between the rear sides and the tub, also rubber one between the sides and the roof if you havent got them

 

D

diko93

Active Member

• Jan 22, 2014

• #6

I need the ones between the roof and sides where can I get them? And where can I get the fixings that go in the tubes in the corners?

 

mark-d

Well-Known Member

• Jan 23, 2014

• #7

diko93 said:

Im converting a truck cab 90 to a van I have the sides roof and back door is there some special mounts to bolt the sides on or is it just normal holts and washers cheers andy

Click to expand...

you can use the 2 special studs from your truck cab and you will need two more of them for the back corners or you can improvise with washers, the rest are normal nuts and bolts

 

D

diko93

Active Member

• Jan 23, 2014

• #8

Cool cheers where can I get these special studs?

 

mark-d

Well-Known Member

• Jan 23, 2014

• #9

not sure but this shows what you need Roof Assembly, Mounting Hardware for Defender - Rovers North - Classic Land Rover Parts

no.17 and attached nuts/washers