10990814_10203611018818304_1560656380291434959_n.jpg
 
I fear my funny (to me) tongue in cheek upload may have been the kindling of this threads fail fire, twas not my intention @scottdej , soz.
But I didn't stoke it.

Side winders, is that the name for side slung silencers?
 
myfirstl322 said:
I fear my funny (to me) tongue in cheek upload may have been the kindling of this threads fail fire, twas not my intention @scottdej , soz.
But I didn't stoke it.

Side winders, is that the name for side slung silencers?
Click to expand...

Nothing to do with you...he asked for comments didn't like them cause they weren't what he expected...so decided to take the huff...

Bit like the plonker in Spain trying to matriculate a "custom"v8 defender in Portugal a while back...They ask for comments\advice thinking everyones going to agree\listen and pat them on the back...I come here for advice\comments\ opinions and listen to whats said
 
Last edited:
Greetings greetin jock...........:D

I'll call you mum, btw that Gin will be the ruin of you, nod nod, wink wink.
 
Last edited:
Me neither really, apart from the Fiddichhhhhh.
I think it all depends on whether you were a troublesome babby and/or your mother/Nanny was semi munchausens/post natal.....;);)
 
Last edited:
scottdej said:
Hi guys
Tvr bought there exhaust down either side of the car like a true v8/yank.
I'd like to do this to my p38, but with the fuel tank and air tank in the way it seems impossible, so what's everyones thoughts on this idea:
A duel entry and exit centre box, coupled with a y branch to swap the sides over and get an equal tuned pipe out of the back.
I know about tuning the pipe to the engine so swapping left to right via the y branch would theoretically give an equal run to each side of the engine under the car, and possibly let the engine perform better.

Comments welcome
Click to expand...
I think you've received fair comments.
You have a 4.6 rover v8 in a p38. It's not fast and the cost / benefit analysis of making it fast is eye watering. If you have swallowed the mark Adams £700 placebo it will have a good fuel map, with very little gain in power over standard. It's not like he can raise the boost pressure. The exhaust mod might gain 15bhp. Do it badly and it will lose bottom end.
Tvr needed to bring the exhaust in front of the engine but it didn't gain anything. Just put a hot spot where you don't want one. They also took a hard boff of glue before they quoted horsepower figures. If you're using standard throttle, inlet, and heads, there are bigger gains to be found getting the charge in than blowing it out
 
You must log in or register to reply here.

Similar threads

M
D1 EFI manifolds and exhaust into One Ten V8 CSW
Replies
4
Views
433
Mik87
M
MrGorsky
P38A Britpart V8 exhaust mismatch with CATS-2-U headers....
Replies
12
Views
2K
MrGorsky
MrGorsky
P38 Monkey
P38 4.0 GEMS 1997 - exhaust gas in coolant
Replies
2
Views
746
Mark Piercy
Mark Piercy
SNOman
How to: de-ASBO my old V8
2 3
Replies
44
Views
2K
6pot
6pot
alexmcrobbie
P38A M51 to Rover V8 Swap?
Replies
16
Views
2K
Grrrrrr
Grrrrrr