bukko

Well-Known Member

Full Member

• Nov 13, 2013

• #1

Hi,

I'm just changing this pipe but the end that goes into the throttle body seems to be pretty tight.
The other ends came out easy enough.
I don't want to break anything by doing it wrong. Is there some trick to removing this or is it just down to brute force?

 

T

thizzlemania91

Active Member

• Nov 13, 2013

• #2

Isn't there a push fit to it? If so just press the collar down and pull the pipe out. You do need a little force to it.

 

bukko

Well-Known Member

Full Member

• Nov 13, 2013

• #3

There is indeed, just couldn't see it because that end of the pipe has a similar collar on it where it joins a nozzle.
Just had to get a flat ended screwdriver in there, Bob's yer uncle, Fanny's yer aunt.
(Your relatives may vary)

 

Nodge68

Well-Known Member

• Nov 13, 2013

• #4

bukko said:

Hi,

I'm just changing this pipe but the end that goes into the throttle body seems to be pretty tight.
The other ends came out easy enough.
I don't want to break anything by doing it wrong. Is there some trick to removing this or is it just down to brute force?

Click to expand...

Which pipe? There are 2!!
:nopics:

 

Nodge68

Well-Known Member

• Nov 13, 2013

• #5

Doh you done it then?

 

bukko

Well-Known Member

Full Member

• Nov 13, 2013

• #6

Quite right stoopid question without pics!