smudge67999
Active Member
hi guys have posted on cruise control problem a few times now. so just a up date been following the rave link on how to test it all out.so now finally gone over the test again today now all gone well apart from a small hitch.the brake test part. it says connect my volt meter between terminals black wire ground and green and purple wire. press brake pedal and should have voltage. now when i perform this test before i press brake pedal i am all ready getting battery voltage then when i press brake pedal voltage goes away. now is the rave got it the wrong way round or is there a fault with my system. see i would think my way is right because hitting the brake pedal breaks the connection which knocks cruise out of operation am i right.if so then it must now only be dry joints on the board which im in the middle of doing now.but i did buy a second hand module but still no luck. but all tests on cruise control and the vaccume test all passed so a bit stumped. this is on a discovery es 3.9v8