lynall · Jul 6, 2017

Im not sure if the britpart mounts will cause you any real issues, they wont be as refined as oe ones but for a crude car like the defender will be fine, I have the britpart ones on mine fine so far.
I have genuine 90 ones on my series 2 with tdi conversion and yes they did make a difference compared to the std small series mounts, but thats an even cruder car!

zeaphod · Jul 6, 2017

You should be able to put a thumbnail into the rubber of the engine/gearbox mount quite easily, any harder and they will pass quite a bit of vibration.

Al2O3 · Jul 6, 2017

HeywoodFloyd said:
What on earth are you doing coasting at 60mph out of gear?! lol.

Listening.

zeaphod said:
12 years/100k is fantastic for a set of UJs in my experience. If you want to be paranoid about sounds/vibrations you've got the right vehicle! (don't forget to worry about the CV joints)

I'm not paranoid.

Or, am I

When you've got an engine that is suddenly a lot quieter and smoother you notice other things. After a while I've decided to investigate and sort it out if I can.

lynall said:
Im not sure if the britpart mounts will cause you any real issues, they wont be as refined as oe ones but for a crude car like the defender will be fine, I have the britpart ones on mine fine so far.
I have genuine 90 ones on my series 2 with tdi conversion and yes they did make a difference compared to the std small series mounts, but thats an even cruder car!

Yeah, the mounts should be ok. I'll take the props off first and see what they look like.

Al2O3 · Jul 6, 2017

zeaphod said:
You should be able to put a thumbnail into the rubber of the engine/gearbox mount quite easily, any harder and they will pass quite a bit of vibration.

IIRC they were pretty hard when I got them. They'll be next on the list after the props for investigation.

Saint.V8 · Jul 6, 2017

You could remove each prop in turn and run with diff lock engaged (not at 60mph mind!!) and see if the vibrations change/reduce/disappear

Al2O3 · Jul 6, 2017

Saint.V8 said:
You could remove each prop in turn and run with diff lock engaged (not at 60mph mind!!) and see if the vibrations change/reduce/disappear

Good thinking, batman!

I'll defo do that.

frog hopper · Jul 8, 2017

Some years ago I happened to be changing a set of uj's when a mate pulled up. He showed me how to put a shallow groove across the end of the bearing spider to help get grease into all cups. He did this with a fine cutting disk in an angle grinder, cleaning up after to get rid of swarf. Did seem to make a difference.
Its' only after reading this thread that I remembered

I'll try and remember for next time.

lynall

Well-Known Member

zeaphod

Well-Known Member

Al2O3

Well-Known Member

Al2O3

Well-Known Member

Saint.V8

Dyed-in-the-wool 100% RR Junkie

Al2O3

Well-Known Member

frog hopper

Well-Known Member

Similar threads