sinclair182
Active Member
Just away to do mine for the first time have a look at busters how to guide, its helped me out. And as far as I know ther all the same but certain types(brands) are less hard wearing than others,
jamesmartin
Well-Known Member
there are 2 sizes ,yours should be rtc3458 smaller of the two ,the larger been rtc3346
discomania
Well-Known Member
Halfords | Comma CV & Lith-Moly Grease 500g
It should be pre-greased but load it right up.
Make sure you get ones with grease nipples, the sealed for life ones just mean "sealed for there far shorter than the other ones life".
I use molyslip but thats just because I have a big can of it, a bit expensive to be using it for general greasing but it works well!
Get a G-gun from screwfix or machinemart.
It should be pre-greased but load it right up.
Make sure you get ones with grease nipples, the sealed for life ones just mean "sealed for there far shorter than the other ones life".
I use molyslip but thats just because I have a big can of it, a bit expensive to be using it for general greasing but it works well!
Get a G-gun from screwfix or machinemart.
Kernow oli
New Member
I don't mean to sound stupid but this is probably a stupid question?! How do you get the grease from the pot to the gun?? ie, if you don't have a grease cartdridge?? Does a normal grease gun work??
Cheers
Oli
Cheers
Oli
Its messy, you either remove the gun pump end and plunge the gun body into the grease and slowly pull the handle out as you push the gun further in, or you pull the handle back a couple of inches and stuff some grease into the gun, then pull it back a bit more etc etc.
Lynall
