It's not difficult. Take plenty of pictures when taking it apart.Maybe see when the time comes. Gonna have Nightmares about it now
border
Well-Known Member
Will use engine hoist when it comes back, it belongs to a Mate but we all share it amongst each other. It is just sitting on pallet at the moment, Looks like its the nuts that come off, are the bolts part of the engine ??
Attachments
border
Well-Known Member
Cheers Mate, Will start spraying with WD40 next few nights.Sorry, yes. I think they're mostly studs with nuts.
You should be ok. It's normally having to lie on your back under it or standing on the bumper with your head wedged between the back of the cylinder head and the bulkhead that makes getting the nuts off a bit tricky.
You don't have that problem. A couple of the bottoms ones might be tricky for you. Lift the transfer box end up a tad and get the bottom ones first.
border
Well-Known Member
Thanks Again,
Remember you've promised @marjon you're going to do it yourself. Much better sense of job satisfaction.
LincolnSteve
Well-Known Member
Clutch alignment needn't be complicated. This was my high tech answer to getting all the bits in the right place. The tube just happened to fit the spigot bearing nicely and then more and more duct tape was added to fit the splined bit of the friction plate. It all lined up and the engine and gearbox went back together easily. It's not finished yet so still haven't had to use the clutch yet so time will tell. It's on a series 3 by the way.
border
Well-Known Member
Quite pleased with progress today, new clutch fitted then engine and box back on Chassis, started to fit shocks but was not sure of which way they went, so waiting to get advice in another post before I go ahead and tighten them all up.
Will order new timing kit and waterpump ect when funds allow, Not sure what to start next
Will order new timing kit and waterpump ect when funds allow, Not sure what to start next
Attachments
border
Well-Known Member
Just a few more pics, Hitting problem after problem now but will eventually get through them 1 by 1, well hopefully Been trial fitting a few bits, rear tub, seatbox and tunnels, once they are lined up and I know they are gonna fit, they will be cleaned up before finally fitting.
Been trial fitting a few bits, rear tub, seatbox and tunnels, once they are lined up and I know they are gonna fit, they will be cleaned up before finally fitting.Attachments
border
Well-Known Member
border
Well-Known Member
Getting slowly closer. Hand brake drum done with new shoes, cleaned and refurberd adjusters, front and rear props fitted and greased up, just need one more bracket for rear of exhaust then start building body back up.
Was gonna have a nice sit down after all that but someone in my seat Again
Was gonna have a nice sit down after all that but someone in my seat Again
Attachments
border
Well-Known Member
Might aswell try and do it right when im starting from scratch, Im sure I will have made mistakes along the way but you learn by them so will no next time.Some impressive work there. I cringe when I think of the bodges I’ve done
Thanks MateComing along nicely
I think you are doing a crackin job, especially when you started off as a complete novice (hope you don't mind me saying that) and with a collection of parts in boxes. You seem to have come on tremendously yourself in terms of what you are confidently tackling and doing a crackin job anorl. And we all make mistakes, that's life!
border
Well-Known Member
Don't Mind at all Mate, Im getting better and learning everyday, said it before and will say it again now, Really Couldn't have got this far without the help from people like you on this Forum.
Thanks Everyone. still a way to go though.
