N

neil993

New Member
Hi all i'm new to this site and i have a problem. Recently bought a 53 reg td4 but i've noticed that when i reverse on full lock unless i give some it won't move, i've been told that it could be the tyres because they are all different makes and different tyre depths but also that it could be the VCU what ever that is. Any help would be appreciated thanks as i don't no what to do now.
 
it will be the vcu been over stiff, you can check by jacking one rear wheel up and try turning the wheel with a socket and bar ,different tyres will speed failure of vcu,you can remove prop and vcu and drive on just the front till you can get tyres and vcu sorted
 
just the vcu ,but id replace support bearings at the same time ,if vcu is stiff dont do many miles before removing prop or getting vcu changed
 
Freelander? They are tightish even with a reconditioned vcu.

What's the milage?

Any strange noise when driving on pretty tight turns?
 
If you're using it on road constantly just take the props, vcu & support bearings off, I did that to my wife's TD4 a couple years back and it handles far better than before.

Don't think we'll get any snow round this way for a little while yet!
 
You must log in or register to reply here.

Similar threads

L
Black & Decker BD 195/6 compressor
Replies
0
Views
539
lrmonks
L
T
L322 Vogue reversing problem. Feels like brakes are on !
Replies
8
Views
813
nevillen
nevillen
Atomician
12-24v lights. Does input voltage change output brightness?
Replies
5
Views
447
300bhp/ton
300bhp/ton
D
Discovery Sport Smart settings trouble
Replies
0
Views
295
discogal24
D
K
Landrover defender 300 tdi engine noise after having gasket done ???
Replies
5
Views
367
lynall
L