twizzle

Active Member

• May 19, 2015

• #1

hi
has anybody done the bearing on the rear output shaft on the transfer-box is there an easy way of doing it without taken the box out

twizzle

 

fanatic

RESPECT IS EARNED, BEATINGS ARE FREE ;-)

Forum Sponsor

• May 19, 2015

• #2

Yes dr
Drain oil
remove output nut,
Remove speedo
Remove ring of bolts round flange
Remove output shaft
Remove circlip
Remove bearing and oil seal with drift
Clean flange and rebuild

 

twizzle

Active Member

• May 19, 2015

• #3

thanks fanatic
it all comes apart easy nothing will fall out from inside
has anybody got a diagram of the box

twizzle

 

Last edited: May 19, 2015

fanatic

RESPECT IS EARNED, BEATINGS ARE FREE ;-)

Forum Sponsor

• May 19, 2015

• #4

 

twizzle

Active Member

• May 19, 2015

• #5

thanks again

twizzle

 

twizzle

Active Member

• May 24, 2015

• #6

yesterday i got time to try and do the bearing so took the prop off and found the 30mm lock nut loose so that was the reason for the up and down play in the shaft


twizzle