Hi All,

I have had the disco stripped down today to fit a new bias plate and unseize the linkage and have a few problems i need advice\help with,

The linkage bar down to transfer case is fine free of rust and works manually as it should, and the same for the high low linkage the problem i have is with the lever housing, like a idiot i took it off and tried a hammer to free the sliding shaft (it moves in and out in a left to right motion to engage and disengage diff) and where the lever from the car goes through the sliding shaft something has broke and just wobbles around something has been lost leaving a big hole with just a thin leaver in it.

The stealers havent got a clue what im on about and i cant get it to them as im remote and its undrivable without one i think, i have no idea whats missing or where i get a full lever assembly from hopefully you guys might have a part number somewhere or be able to point me in the right direction i cant find nothing on craddocks or paddok so im a touch lost

Its a 5 speed manual 300tdi on a 98 plate.

Thanks in advance and sorry if it sounds weird.

Cheers

check these out mate

pg. 13 http://www.xks.com/landRover/catalog/pdf/LandRoverCat154_195V4_1.pdf

and chp. 41 http://www.landy.pl/LandRoverDiscoveryWorkshop1995-1996.pdf

i got a new linkage from a breakers yard in bury 01617977050 landrover breakers try them bit far from u though