A

adamkaye12

New Member
just a few questions about 90 arms, i have a 4 inch lift kit but i dont think i have cranked arms? should i exchange my ones for cranked?

i was hoping to refurb some when i find a good set will they need sand blasting or is hand sanding just as good for prep?

thanks lads
 
i have both and they improved how my 90 drove, running a 3 inch lift, i got new front but got second hand rear trailing arms, got them shot blasted and re powdercoated them o looked like new.
 
adamkaye12 said:
just a few questions about 90 arms, i have a 4 inch lift kit but i dont think i have cranked arms? should i exchange my ones for cranked?

i was hoping to refurb some when i find a good set will they need sand blasting or is hand sanding just as good for prep?

thanks lads
Click to expand...

yes you should, your bushes will be under serious strain.

And you wil probably need 6 degree arms rathe than the usual 3 Degree ones. Try QT or Adrenaline 4x4.
 
Hi guys not to sound to much of a dunce, but at what size lift do you need to start adding cranked radius arms and what degrees for what size lifts etc.
 
Ideally as soon as you start lifting it. I think its strongly advised to use corrective arms over 2" of lift. Im not sure what angles of castor correction are required
 
gwyn lewis cranks standard front radius arms and dose a loverly job too :) ive had 2 sets off him (best to ring up for a price) and iv got a pair of heavy duty cranked rear arms again from gwyn :)
 
i have a set of gwyn lewis too, very good :) when do you need to start using a adjustable panhard rod?
 
Davv said:
i have a set of gwyn lewis too, very good :) when do you need to start using a adjustable panhard rod?
Click to expand...

as soon as you lift it.

When you lift the axle away from the chassis your increasing the distance but keeping the same piece of metal so this pulls the axle to one side a little. It can cause 'crabbing' and also your radius arms can foul on chassis.
 
also does anybody have any previous issues with using red oxide primer as apposed to a different primer? i ask as i get it from college quite easily lol
 
ive got the 6 degree arms on the 110 with a 6" suspension lift.... a cheaper option on a 2-3" lift are castor corrected bushes if your on a budget

cheers steve
 
You must log in or register to reply here.

Similar threads

bankz5152
Defender 110 2003 Defender Take Off Parts - radius/trailing arms/a frame/panhard rod
Replies
0
Views
744
bankz5152
bankz5152
S
Discovery 1 4inch lift
Replies
5
Views
915
AJC12
A
F
Paint reaction
Replies
4
Views
739
Stanleysteamer
Stanleysteamer
ChrisBduck
3.6L Land rover 90
Replies
2
Views
863
ChrisBduck
ChrisBduck
L
D2 suspension questions
2
Replies
20
Views
2K
LandiesInThatFrance
L