Here is a picture of mine (not series but essentially the same)
300bhp/ton
Well-Known Member
Series don’t have this. Only on a 90/110.
Agreed, my 2a certainly doesn't have this
300bhp/ton
Well-Known Member
90/110's have the rear stays and point on the chassis to mount them. The drop plate is generally smaller and often bolts to the underside of the cross member rather than the back face of it.
On a Series the drop plate bolts top and bottom on the rear face of the cross member. The drop plate has no mounting points for rear stays and nor does the chassis. If they have been fitted they will have been done aftermarket and technically are not a genuine fitment.
mick dodd
Active Member
i have just fitted a hitch to my 3 lightweight . 12mm holes on chassis 4no.i made a box section bottom support welded to cross member & used 16mm bolts 2no.then unistrut heavy gauge .rather than drill through the chassis i made 2no plates with the 12 mm bolts welded on then welded the plates on .use tensile bolts .no one seems to make kits anymore !
