ogb
Active Member
https://www.screwfix.com/p/erbauer-zirconium-flap-disc-115mm-40-grit/4300g
Try these? Much better than cutting or solid griding discs.
Try these? Much better than cutting or solid griding discs.
Discodevon
Well-Known Member
I just purchased some easy outs, they were only a couple of quid so fingers crossed I can get at least one screw out with them, nothing ventured nothing gained and all that
Discodevon
Well-Known Member
Lads apologies for keeping this thread going but if I get underneath my defender and pull the plastic square nuts off could I just knock the screw up from underneath or not that simple?
jamesmartin
Well-Known Member
yes but they dont knock off easily you need to cut them
Discodevon
Well-Known Member
James thank you! Could I grab the plastic with locking pliers and wiggle it off or still need to cut it?
Have you got some biggish side cutting pliers? You could chop them up from underneath. They'll pull through the square hole in the floor plate better if you can chop them up a bit.
Discodevon
Well-Known Member
Thank you AL I’ll give that a go, to put the new plastic nuts on do I need to push them through from above like a wall plug? If so I didn’t realise that and silly me, luckily so far I haven’t had to replace any of them as the originals have stayed put whilst I’ve undone the screws
Best regards
Yes, you do. They have a lip around them to hold them in place when you push them in to the holes. Then, as the screw goes on, they expand in to the hole. As you say, just like a rawl plug.
Discodevon
Well-Known Member
I just removed this plastic nut thank you chaps, and then realised after removing the screw that I’d have to remove the floor panel completely to get the plastic nut into the ridge,( which I don’t fancy doing) luckily in the kit I have from yrm is the metal clip things so I used one of them instead between the bulkhead and floor I hope this is ok? It certainly looks nice from underneath and screwed down nicely, only one more to do now but the plastic nut is right above the chassis so will be a lot more tricky to get to
Yes, they'll be fine. They're stainless aren't they?
Discodevon
Well-Known Member
Yes there’s stainless and I put loads of grease on it too! Happy days! Thank you
