WildOne said:

Its cost me AUD $1800 and i cant even sell it for AUD $1000 had a guy from the UK look at it the other day and walk away because of the gearbox crunch he mentioned it went into all gears ok but reverse was grinding

When i removed the master cylinder i broke the little black plastic clip that locks the ball over the pin onto the foot peddle however the ball joint was still fine but the center plastic locking clip was removed do u think that 2mm clip could be why my gears are grinding? I couldnt find a replacement anywhere

Click to expand...

WildOne said:

Did your mod work?

Click to expand...

WildOne said:

Thanks Alibro i have a lathe i was going to take some measurements and make a aluminium sleeve to slide in there

Did your mod work?

Click to expand...

WildOne said:

I might actually do the same as you Alibro i have some left over epoxy resin and talc powder in the shed to make a nice thick glue mix, How much did u relocate the hole back in millimeters so i can do the same without riding the clutch? cheers

Click to expand...