This what your looking for?
ACTION:
1. Remove tailgate aperture seal and check flange for irregularities. Carefully
straighten any flange area causing concern and evenly bend entire length of
flange outwards towards tailgate by approximately 5 mm.
2. Obtain new tailgate seal ALR8547. Referring to the illustration on page 2,
measure 520 mm outwards from the lower seal section centre line and mark
seal at these points, measure another 5 mm on from these points and mark
seal again. With a sharp knife carefully cut through the bubble section of seal
at marked points so that a C shaped section is removed to form drain slots,
(see inset on illustration).
NOTE: If modification is carried out correctly the drain slots will be hidden
under the tread plate.
3. Fit seal to vehicle confirming that the seal is the correct way up with seal joint
and drain slots at bottom of aperture.
NOTE: To assist seal fitment and to ensure tightness of seal to flange, the
seal should first be heated to approximately 40 0 C. This can be achieved by
placing in an oven or a container of warm water.