T

tdi300

New Member
Alright chaps I posted this about 10 months ago but money is still to tight to get garage to fix so I'm gonna have a crack myself the original problem was the landrover tdi300 auto 97 was on motorway overheated lost most of the water. oil level right up but no white sludge any where I seen a thread on here how to strip it down so I started to dismantle it when I pulled the intercooler pipe off all inside is covered in oil and when I pulled of the air pipe off after the airflow metre that pipe was also saturated in oil any one shed any light on this I'm just at the point of taking the manifold off now cheers thanks for any help. Mick
 
have you drained sump ,was level of oil very high ? its normal for intercooler pipes to be wet with oil ,its the nature of turbos ,hard to say if its more than normal from here .drain block by undoing bung on lhs of block just in front of down pipe 13mm,dont be afraid of pulling it apart it wont really hurt if push rods etc dont go back in same order ,watch out for valve stem caps on top of valves they easily get lost though not manditory to refit
 
Well the oil level on dip stick is about 3 inches past top mark for the oil level check. I haven't drained oil out yet either mate.
 
i had oil in my pipes when HG went on pot's 3 and 4 on my 200tdi changed gasket clead out pipes all is well now never done it b4
 
Well I'm hoping that will be the case mate. Do I need to do a engine flush after due to the water and oil mixing I know I'm gonna drain it but will that be enough?
 
not if u drain coolent first mate i just changed fillter on mine toped up with oil but my sump plug wos not moving 4 nobody lol
 
tdi300 said:
I can pay in unlimited tea and biscuits if any one wants the job lol
Click to expand...

This is rapidly becoming my favourite rant.

***Fill in the profile section when asking for help so folk know where the frick you are. It's not difficult and don't take long***

That'll do...
 
Sorry i filled in the profile abit more Kingswood Bristol. I will do some more tomorrow p#~ing down at the moment. And in work early today cheers for the replys
 
drained oil and water today. when i did the the oil it looked like pure water coming at first then oil eventually came out just one more nut to remove on the manifold awkward one. wheres best place to get a head gasket from or will ebay do they got some cheap ones but i take it there not worth bothering with cheers guys.
 
If you're doing it you only want to do it once, I got a genuine Landy one that way you *know* it's good (and really not that much more moolah). I seem to remember there being different dot ratings, can't remember what they mean - it would be worth doing a search. Also you want to check a multitude of other stuff (the micro bore pipe that runs from the stat housing, header tank and rad) so when you put it back together it dun't blow again straight away...
 
You must log in or register to reply here.

Similar threads

Lephreek
Possible blown head gasket. What next?
Replies
13
Views
482
v8250
v8250
Bife
Freelander 1 Oil Cooler
2
Replies
28
Views
977
Bife
Bife
O
Head gasket upside down
Replies
14
Views
2K
Obi_110
O
M
D2 - TD5 - sudden oil consumption increase
Replies
17
Views
1K
Malawi_Disco_2
M
J
Oil leak advice red plug
Replies
2
Views
441
Anaconda
A