D

Drymar

New Member

• Jan 6, 2009

• #1

I've been putting off this job for ages as I was told that to replace the front wheel bearings on my '99 TD5, I had to replace the entire hub unit at great cost.
Yesterday, I enquired at my local factors the cost of a front wheel bearing kit and was told somewhere circa £30.00...

So, I am seeking your advice... do I tackle replacing the bearings with the kit or do I have to buy an entire hub...?

Cheers,
Mark.

 

Pikey

Dummy Ejection Facilitator..

• Jan 6, 2009

• #2

Whoever told you that it required a new hub is an idiot. If you had a jeep cherry then yes you would have to replace the whole hub but not wiith a landy.

 

MartinK

New Member

• Jan 8, 2009

• #3

The TD5 hub is not re-buildable. You need a complete assembly. Yes it is expensive (~£180/ corner) as they include the ABS sensors

 

shocker

Well-Known Member

• Jan 8, 2009

• #4

the 300 ES hubs have ABS sensors in and they are rebuildable......is it a totally different unit in the TD5?

 

MartinK

New Member

• Jan 8, 2009

• #5

Yes, they are (very) differect to the 200/300 Disco.

Look up part # TAY100060 - that's the part # for the front hubs (incl abs sensors as a complete unit).

Here's a piccie:
Land Rover Discovery Genuine Factory OEM Hub Assembly TAY100060 TAY100050

One good thing - when you swap them, should be OK for 80k miles (mine have been)

 

M

martinhollings

New Member

• Jan 8, 2009

• #6

yep you need a new hub try here the cheepest i could find but still oem quality Wheel Bearings & Axle Parts -
p38 rane rovers have the same setup but they can be rebuilt

 

D

Drymar

New Member

• Jan 9, 2009

• #7

Thanks for the input guys. Looking at MartinK's link, they look a straightforward part to fit, is that right, or am I missing something.....?

Mark.

 

battenberg

Well-Known Member

• Jan 9, 2009

• #8

easy enough to fit, shifting the nut on the end of the drive shaft is another matter..!

check yer CV gaiters are OK, replace them at the same time if not.