marvinb · Jul 7, 2013

Hello, i was wondering if anyone else has had this problem? Set digital display to LO, both sides, but only get warm air. If i raise the temperature on digital display, air remains warm with no change until it gets to HI, then you get REALLY hot air con seems to be charged, so not sure whether its a problem with digital control unit or something just isn't switching over, or hopefully something even more simple. Any advice welcome

discool · Jul 7, 2013

Climate control a/c is very involved with it's sensors and servos, you should get it plugged in to Testbook or similar to diagnose any faults, it could be as simple as the ambient temp sensor on the top of the dash being faulty, which you will find when it's tested.

sierrafery · Jul 7, 2013

marvinb said:
Hello, i was wondering if anyone else has had this problem? Set digital display to LO, both sides, but only get warm air. If i raise the temperature on digital display, air remains warm with no change until it gets to HI, then you get REALLY hot air con seems to be charged, so not sure whether its a problem with digital control unit or something just isn't switching over, or hopefully something even more simple. Any advice welcome

Run the manual diagnostic procedure on it maybe it reveals something... if no fault codes watch the compressor clutch while somebody switches on the aircon and see if it engages or not... it's not set on ECON by mistake isnt'it

see attachment

Td5D2 · Jul 7, 2013

Air con might need regassing.

marvinb

Member

discool

Well-Known Member

sierrafery

Well-Known Member

Attachments

Td5D2

New Member

Similar threads