kernowsvenski

Well-Known Member
I'm about to embark on the thermostat mod for my TD4 auto. There is a fair bit of info on here about it but I'm wondering about a definitive discussion/summary of the pros and cons of the two different temp options that seem to be most widely used.

Is the 83° or 89° preferred?
 
Is the Renault solution really simply a matter of disconnecting the top hose and stuffing the Renault thermostat into the hose, with the copper bit facing the engine, and replacing the hose.

I ask as my 2005 auto suffers from a lukewarm heater and a needle that does not rise above a third.









I
 
Is the Renault solution really simply a matter of disconnecting the top hose and stuffing the Renault thermostat into the hose, with the copper bit facing the engine, and replacing the hose.

I ask as my 2005 auto suffers from a lukewarm heater and a needle that does not rise above a third.
I

Yes. But the auto's top hose is shorter and smaller in ID than the manual box top hose. You can still get the Renault stat in though. It just takes more muscle and lubrication.
20160522_140014.jpg


The swollen lump in the top hose, is the thermostat inside.
 
Thanks Nodge , it seems simple enough just to take off that short length of hose. What’s the tip for easing the thermostat in, heat the hose and apply washing up liquid?
 
Thanks Nodge , it seems simple enough just to take off that short length of hose. What’s the tip for easing the thermostat in, heat the hose and apply washing up liquid?
A short length of pipe the right diameter so you can push against the casing and not the tip. Also avoid the QH thermostats as their casing isn't as curved so they're harder to push in.
 
Thanks Nodge , it seems simple enough just to take off that short length of hose. What’s the tip for easing the thermostat in, heat the hose and apply washing up liquid?

I find the silicone grease works best as a lubricant to slip the stat into the pipe.
 
No. The hotter the engine runs, the more efficient it is. Just don't use a 5w30 oil, use a 10w40 instead. ;)
Fair enough. Thanks @Nodge68
My last oil change was not so long ago. I have 5w30 fully synth in atm. Might be worth me waiting for a few miles before doing it then, and combine it with my next oil change..
 
I find the silicone grease works best as a lubricant to slip the stat into the pipe.

Thanks once again Nodge, just a final question for you. Looking at the photo of your car it seems the copper spigot of the thermostat is probably half way into the plastic pipe union judging by the bulge location in hose.

I guess as your car is stil driving well that’s no problem?
 
Thanks once again Nodge, just a final question for you. Looking at the photo of your car it seems the copper spigot of the thermostat is probably half way into the plastic pipe union judging by the bulge location in hose.

I guess as your car is stil driving well that’s no problem?

I fitted the stat into the hose just far enough so sensing bulb of the stat was in the T piece. This means it can react to the coolant temperature quickly.
 
Last edited:
Thanks. I guess it would be difficult to force the thermostat into the hose much more deeply and the more quickly it reacts to temperature the better.

I could have done with the heating working efficiently today but I will have to wait for my thermostat to arrive from eBay.

Thanks again for your guidance.
 

Similar threads