freelandy2004 · Mar 3, 2018

hi iv got an intermittent fault, poor idle on start up ranging from, running ok, to poor idle gets better when warm, to a judder ruff idle and you can feel it though the seat. sometimes slightly raised idle speed.
white smoke if revved smell of un burnt fuel
starts first time every time and have tried couple of bottles diesel magic
I was thinking injector, fuel pressure sensor, before I got start doing leek back test ect
i had it on a diagnostic machine only fault stored was
A ''faulty coolant temperature senor''
cleared it didn't come back on when engine was started but its running ok at min
would this sensor course my problems
any help appreciated

Nodge68 · Mar 3, 2018

Any sensor fault can cause a degree of running issues. So any suspect component needs changing, if running problems are to be avoided.

freelandy2004 · Mar 3, 2018

Nodge68 said:
Any sensor fault can cause a degree of running issues. So any suspect component needs changing, if running problems are to be avoided.

thanks for reply can this be done without draining down cooling system
I was thinking disconnect sensor, loosen take out thumb over hole slip other one in quick
minimal loss of coolant top up

Nodge68 · Mar 3, 2018

freelandy2004 said:
thanks for reply can this be done without draining down cooling system
I was thinking disconnect sensor, loosen take out thumb over hole slip other one in quick
minimal loss of coolant top up

That's the way, although if you have the new sensor in your hand, there's no need for the thumb part of your plan.
Make sure the engine is cold and leave the cap on. This will reduce the flow of coolant to more of a trickle.

freelandy2004 · Mar 3, 2018

Nodge68 said:
That's the way, although if you have the new sensor in your hand, there's no need for the thumb part of your plan.
Make sure the engine is cold and leave the cap on. This will reduce the flow of coolant to more of a trickle.

thanks for help just been reading up sounded a bit ott to drain hole system and is there a good reason for disconnecting
the battery for one connection

Nodge68 · Mar 3, 2018

freelandy2004 said:
thanks for help just been reading up sounded a bit ott to drain hole system and is there a good reason for disconnecting
the battery for one connection

No need to drain the system or disconnect the battery. That sounds like Haynes manual instructions to me.

freelandy2004 · Mar 5, 2018

why is as soon as you press ''buy it now'' the bloody thing run ok
I have notice the smell of un burnt fuel is from front end so possible fbh that isn't working
and when it running ok and you turn the ignition off it shuts down clean
when it's running lumpy turn the ignition off total different sound even lumpy shut down

Nodge68 · Mar 5, 2018

Check the HP fuel pump for leaks. HP leaks are a common cause of diesel smells from the front.

freelandy2004 · Mar 8, 2018

hi little up date
iv ordered a coolant temperature sensor its arrived but I haven't had chance to fit it yet
while I was waiting I had a good look around the engine couldn't find anything amiss
thankfully couldn't find any leaks to HP pump either but I will check again when I fit the coolant sensor
but good news

after reading on here I decided to removed and cleaned he the air intake temperature sensor
this has made a big difference better idle more low down drive to it
touch wood its been good for two days now much nicer to drive
im still going to fit the coolant sensor and will probably clean the inlet manifold out again while its off
is there any special way or product too clean the MAP sensor
while im on a roll
cheers

teddywood1 · Mar 8, 2018

Do not poke anything into the map sensor .

Skinny Mike · Mar 9, 2018

Brake cleaner or MAF cleaner work well on the MAP sensor, as @teddywood1 says, don't stick anything down the little hole.
Mike

freelandy2004 · Mar 9, 2018

teddywood1 said:
Do not poke anything into the map sensor .

Skinny Mike said:
Brake cleaner or MAF cleaner work well on the MAP sensor, as @teddywood1 says, don't stick anything down the little hole.
Mike

Thanks guy's are you ok spraying directly down the little hole to flush any gunk out from inside
or is that not a good idea
cheers

Skinny Mike · Mar 9, 2018

Yes, that's ok
Mike

freelandy2004

Active Member

Nodge68

Well-Known Member

freelandy2004

Active Member

Nodge68

Well-Known Member

freelandy2004

Active Member

Nodge68

Well-Known Member

freelandy2004

Active Member

Nodge68

Well-Known Member

freelandy2004

Active Member

teddywood1

Well-Known Member

Skinny Mike

Well-Known Member

freelandy2004

Active Member

Skinny Mike

Well-Known Member

Similar threads