Im not sure what to do next so Ill tell you the problem and what Ive done so far.
My car 52plate TD4 automatic wouldnt start and the RAC said it was the fuel pump. It went to a garage where it had the connections on the pump cleaned up as they were dirty. It started and has done ever since. Now there is a problem changing gears. If Im at a stand still and floor it, the revs will go up but the car will crawl along. If I take it steady the car will change up ok. If Im driving at speed and again try to accelerate hard it used to kick down and pull away nicely. Now it will only rev high with no gear change at all. I took it to a garage and they plugged it in to a scanner to see if it had a fault code. It came back with P1260 Delivery fuel pressure management. He cleared the code and I took it for a drive but it was still the same. He re-connected it and the fault code was back. He typed the fault code into autodata and it came back with a different fault P1260 Fault location -Engine disabled by PATS. Problem cause Incorrect/damaged key, wiring, immobilizer defective, ECM.
I have no idea what I should do now. The car drives ok as long as I dont need any quick acceleration. What should I do?
Thanks in advance for your help and advice
My car 52plate TD4 automatic wouldnt start and the RAC said it was the fuel pump. It went to a garage where it had the connections on the pump cleaned up as they were dirty. It started and has done ever since. Now there is a problem changing gears. If Im at a stand still and floor it, the revs will go up but the car will crawl along. If I take it steady the car will change up ok. If Im driving at speed and again try to accelerate hard it used to kick down and pull away nicely. Now it will only rev high with no gear change at all. I took it to a garage and they plugged it in to a scanner to see if it had a fault code. It came back with P1260 Delivery fuel pressure management. He cleared the code and I took it for a drive but it was still the same. He re-connected it and the fault code was back. He typed the fault code into autodata and it came back with a different fault P1260 Fault location -Engine disabled by PATS. Problem cause Incorrect/damaged key, wiring, immobilizer defective, ECM.
I have no idea what I should do now. The car drives ok as long as I dont need any quick acceleration. What should I do?
Thanks in advance for your help and advice