Hi guys and girls
I've been sitting here most nights searching over this forum and its have helped me an amazing amount but it's time now to ask for some ideas and help as its getting expensive

Basically it a 2003 TD4 Freelander
It began taking a while to turn over ... upto 1 min or so. Once started it drove very well
After about a week or so of odd starting times, it just wouldn't fire into action (had 1/4 tank of diesel at this time, lowest it had been)

firstly the Fuel pump under the wheel arch was changed and with a bit of easy start it fired into life and ran for a day or so (without using easy start again), starting better than it used to

Next it went on an hours journey and after being switched off it refused to start the next day
Bump starting etc.. a friend managed to get it going (not sure what he did as i wasn't there).
But as soon as the revs went past 1000 it just cut out

So a couple of hours ago, i tried the leaky injector test.. found out 2 of them were leaking. luckily sourced some up and swapped them over, It started first time and within seconds... but as soon as the revs go past 1000 it still dies...

Engine Idles fine, no smoke etc

Can anyone suggest where to look next, could it be the Fuel pump regulator or even the high pressure pump its conected to ? could it be something other than the fuel supply?

Also tried unplugging the MAF sensor and this did nothing

Any help would be appriciated,

Sion

Is it just cold starts when you have problems? Could be a cam sensor.

Always worth looking at the high pressure plug at the end of the fuel rail - these are known to "green" up. Clean with some electrical contact cleaner. If the plug is too bad the plug and loom can be changed - part costs approx £40 from LR

good luck

Hi Zoolander
It seems to do it either hot or cold

As i say it starts first time everytime now that 2 injectors have been replaced (no easy start needed)

Just Keeps cutting out at 1000rpm

starts again fine after that

I'l have a look at that sensor and give it a clean tomorrow, forgot to mension that i already bought a new wiring Mod for that sensor as apparently sometimes it can help

Thanks for your info