just replacing the front drive shafts, along with a lot of other bits, left side gone back a treat, however, the fight side will just not slide into the ird/gearbox try as i might.
any ideas?
just replacing the front drive shafts, along with a lot of other bits, left side gone back a treat, however, the fight side will just not slide into the ird/gearbox try as i might.
any ideas?
the new and the old, but paddocks say its the right one for the vehicle, even gave chassiss number etc, and still it wont fit after 2 days of twisting banging cursing
You need to check that the bearing support journal (smooth surface below the spline) is the same size as the original joint.
There are also no C clips in the grooves.
It's not an OE joint, so will probably vibrate anyway.
I'd only fit an OE (GKN) joint, as aftermarket replacements vibrate on the Freelander.