R

Rorie

Active Member

• Feb 3, 2020

• #1

FA defender (1990)
Just stripped down the swivels for a rebuild. The bottom pin has a bearing, but I was expecting thrust washers to come out the top, but there is nothing. Is that normal?!

 

jamesmartin

Well-Known Member

• Feb 3, 2020

• #2

any pics

 

R

Rorie

Active Member

• Feb 3, 2020

• #3

Hope these help?
Showing the bearing that goes into the bottom of the swivel and the pin that goes into the top.
Landy tool box videos shows two washers with a thrust breathing between going into the slot in the top of the swivel that’s then compressed by the top pin.

 

R

Rorie

Active Member

• Feb 3, 2020

• #4

Here is a screenshot from YouTube showing the thrust washer and then a photo of my parts catalogue. Part 5 FRC2906 when I look up on Paddock doesn’t look the same.
Regardless, when I stripped the hub there was nothing in there!

 

Attachments

• 
  B20844B2-7189-4363-8DF2-7C0BE54CFCD0.jpeg

  219.1 KB · Views: 64
• 
  EE255AF6-C87D-4F84-A533-03F74862FE33.png

  244.3 KB · Views: 84

jamesmartin

Well-Known Member

• Feb 3, 2020

• #5

Rorie said:

Here is a screenshot from YouTube showing the thrust washer and then a photo of my parts catalogue. Part 5 FRC2906 when I look up on Paddock doesn’t look the same.
Regardless, when I stripped the hub there was nothing in there!

Click to expand...

you should have one rialko washer no5 in your parts screen shot, the vid is a disco abs type,it uses a similar pin to early defender so sensor can fit in it

 

R

Rorie

Active Member

• Feb 3, 2020

• #6

Thanks for confirming. Defo nothing in there when I stripped down... I’ll add when I rebuild, but would it have caused damage not being in there at all?

 

jamesmartin

Well-Known Member

• Feb 3, 2020

• #7

surprised it shimmed up ok

 

R

Rorie

Active Member

• Feb 3, 2020

• #8

Seemed to be ok. But I decided to renew seals and rebuild as I didn’t know quality from before I purchased. Hopefully no damage and I can rebuild ok!

 

R

Rorie

Active Member

• Feb 3, 2020

• #9

Just checked again now I known I’m not looking for thrust bearings- I can see the washer in the housing!

I assume I don’t need to change the top and bottom pin, but would I need to change the washer when rebuilding?

 

jamesmartin

Well-Known Member

• Feb 3, 2020

• #10

Rorie said:

Just checked again now I known I’m not looking for thrust bearings- I can see the washer in the housing!

I assume I don’t need to change the top and bottom pin, but would I need to change the washer when rebuilding?

Click to expand...

bottom pin doesnt even need removing and very unlikely it needs changing, normally youd change top pin,bush and washer if there was any wear,plus bottom bearing