any of you folks know what type of material is used as a gasket between a supercharger and inlet adapter?
is it a silicone type or paper? or summat else?
is it a silicone type or paper? or summat else?
If you need a gasket for a Eaton M45 just go to a friendly BMW dealer and buy one, its steel with sealant already on it.
and it's cheap enough not to make your own...
it aint an m45.
its to fit on a lexus lump.
its to fit on a lexus lump.
Hot side?
i would think so - inlet manifold adaper.
Would have to be a composite then, will a OEM not fit?
not sure - will have to get kwakkers to post - its his motor.
If it's 'near', then a trim with a dremel and a smear of HT sealant should do, did it come as a SC kit with the adaptor?
