H

Harrris303

Active Member

• Aug 31, 2011

• #1

I'm replacing the exhaust on my series 3, and just stripped one of the manifold studs. Has anyone got any suggestions as to how best to get studs out? (preferrably without taking out the manifold)
I've been doing some research but most of what I've seen will only work on studs with a good thread.
Need help badly,
cheers.

 

oxides

Well-Known Member

• Aug 31, 2011

• #2

You could try a stud extractor or a small pair of stilsons but I bet you'll snap the stud off. Then it's manifold out and drill the stud out time, I'm afraid.

 

Series71

Space man

• Aug 31, 2011

• #3

you'll struggle to get it out.....I snapped all 3 studs with an extractor and lots of wd40 with the manifold out !

 

pef77

Active Member

• Aug 31, 2011

• #4

as a temp fix get a die and stocks or even a die nut and re thread to a slightly smaller size and use a washer... it wont be as strong but will get you by

 

GingerPuss

Active Member

• Aug 31, 2011

• #5

I was in the same boat when I had to replace my exhaust a year or so ago...I found it was just easier to buy a new manifold:
Exhaust Manifold 4cyl - 4cyl Petrol

Deffo cheaper than the labour costs for a garage to helicoil.

 

H

Harrris303

Active Member

• Sep 3, 2011

• #6

Thanks for the input everyone. Turns out I've had a go at the dreaded rusty manifold nuts and so far it seems they're actually gonna come off fairly easily. (Some of them weren't even tightened...)
So I'm thinking new manifold like Gingerpuss said (if I can't get the studs out). Seems too easy though, as always something's bound to go wrong.
Thanks again guys.

 

oxides

Well-Known Member

• Sep 3, 2011

• #7

If it's the petrol there's a difficult to reach nut on the top of the middle branch. I think you have to remove the inlet manifold to get to it, otherwise it's straightforward. Replace all three gaskets.

 

nrgserv

Well-Known Member

• Sep 3, 2011

• #8

if the manifolds comin off, clamp stud in vice an heat manifold next to stus untill dul cheery red. apply forwards backwards twisting motion to manifold until you feel stud turning.
dont burn yer fingers.