discodrivercumbria
Well-Known Member
it does!
discool
Well-Known Member
Don’t hold your breath
as u may have found out elsewhere those details aren’t listed by LR.
Last edited:
stuu
Well-Known Member
Don’t hold your breath
That's what mine measured at just no sure what its actually ment to be
sierrafery
Well-Known Member
The heights are listed in the WSM - General data - Suspension
Nominal height from hub centre to wheel arch (not liner):*
* Measurement taken with vehicle at unladen weight all 4 corners.
- Coil springs 483 ± 15 mm (19.0 ± 0.6 in)
- Air springs 473 ± 15 mm (18.6 ± 0.6 in)
IMO with SLS the best would be to have the same values all around
Nominal height from hub centre to wheel arch (not liner):*
* Measurement taken with vehicle at unladen weight all 4 corners.
- Coil springs 483 ± 15 mm (19.0 ± 0.6 in)
- Air springs 473 ± 15 mm (18.6 ± 0.6 in)
IMO with SLS the best would be to have the same values all around
stuu
Well-Known Member
Thank you. I did try downloading rave the other day. Didn't work out very well gave up after a while
sierrafery
Well-Known Member
berg450
Well-Known Member
Mine is around 500mm at the front (new springs and dampers) and set to about 480mm at the rear (air springs).
Have you also checked the bump stop height (top of bump stop to axle bracket) which should be about 45mm at front and about 60mm at the rear.
Can you please tell me what springs you installed, I mean part code and if genuine or britpart?
I have tough times to find a replacement for my original white/purple, so any advice counts.
To answer to this thread:
- front with new Pink/Brown springs 510mm - too stif for my taste, looking to revert back
- rear air springs 475mm
berg450
Well-Known Member
I have these:
REB000330 OEM
DA1008 Bilstein B6
my car is a 2003MY td5, LHD, manual, with ACE and Air con.
