Hi All
4.0 Thor 2000
I know that apart from fitting a new cam kit, one has to, and I quote from an earlier post

"All you have to do is undo the torx head bolt holding the handle on and then wriggle the door handle outwards until you can see the offending lug that needs cut off - you can move it out far enough to get a pair of pliers on to it and just gently twist it sideways and it will snap off dead easy
Just make sure that the pin the mechanism hinges on is in place to begin with or removing the lug will not work - if this is the case then you will have to replace the pin too"

So the kit is in the post but before I take the handle out I would appreciate someone posting a picture if possible of the offending lug.-would hate to lop off the wrong bit.
Many thanks
Simon

Not taken any pics when had to delve into door handle issues. But would guess/hope it would be obvious once you get the kit. What kit?

Post pics for others when you do it please.

J

marjon said:

Not taken any pics when had to delve into door handle issues. But would guess/hope it would be obvious once you get the kit. What kit?

Post pics for others when you do it please.

J

Click to expand...

STC 3064 Door lock cam kit-inc plastic cam, spring and little rod. The kit does not show the offending lug to remove.Am sure you are right about it being obvious but this request really on the offchance someone can identify it.

simoncant said:

STC 3064 Door lock cam kit-inc plastic cam, spring and little rod. The kit does not show the offending lug to remove.Am sure you are right about it being obvious but this request really on the offchance someone can identify it.

Click to expand...

Might be on rr.net