why bother when you can buy one so cheaply ?
Landrover special steering wheel tool/puller Land rover on eBay (end time 29-Jun-10 10:31:31 BST)
Landrover special steering wheel tool/puller Land rover on eBay (end time 29-Jun-10 10:31:31 BST)
yes thanks
instantsquid
New Member
The picture above is a good place to start if you want to make one - I made my own (didn't know you could buy them so cheaply!) - bit of metal bar, three holes, three bolts and one nut. The outside bolts screw into the threaded holes in the steering wheel. The middle bolt with a nut on it is used to push against the steering column.
Shifty1962
Well-Known Member
Loosen the nut holding the wheel on - dont take it off completely.
Take a soft faced hammer and while pulling on the wheel give the top of the steering shaft a few good taps. Works every time for me.
When you put the wheel back on use some copper slip and it will come off easily next time. Also dont do the nut up too tight.
Take a soft faced hammer and while pulling on the wheel give the top of the steering shaft a few good taps. Works every time for me.
When you put the wheel back on use some copper slip and it will come off easily next time. Also dont do the nut up too tight.
