plastic soul
Active Member
Got some spots to fit, just wondered what size cable to connect them with....amps wise?
what current do the spots take?
Bromsgrove Defender
Well-Known Member
Amps = Watts divided by Volts.
wiltshire landyman
I’m back
come on there spots ..hes already gave u all that info u need to give him the correct rated cable
no he hasnt
Bromsgrove Defender
Well-Known Member
pssst
I think he was being moronic
really?
wiltshire landyman
I’m back
u have to make allowances for mhm the lift don't quite reach the top floor:bounce:pssst
I think he was being ironic
Bromsgrove Defender
Well-Known Member
plastic soul
Active Member
100w
DEFENDER90-DAZ
New Member
100w x2 or x4 or x6 or x8 ???
plastic soul
Active Member
7 or 8 amps?
Bromsgrove Defender
Well-Known Member
wiltshire landyman
I’m back
lz crystal ball anyone?
plastic soul
Active Member
put that in b4 you replied.....
A grand total of 2 lights wipac 8"
A grand total of 2 lights wipac 8"
DEFENDER90-DAZ
New Member
So it 2 x 100w lamps then
200 / 12 = 16.6666666 amps drawn by both lamps
200 / 12 = 16.6666666 amps drawn by both lamps
So it 2 x 100w lamps then
200 / 12 = 16.6666666 amps drawn by both lamps
so use 25A
Bromsgrove Defender
Well-Known Member
T'is likely to be a bit more n that
Watts dived by volts = Amps
ei
2 spots X 100 w/ 12volts = 16.66 Amps always use a higher rated wire as MHM says
Always use as close or lower fuse rating
Dont forget to use a relay and in line fuse from a seperate power source and they're own switch.
The relay can be switched from the main beam feed if you want them to come on with the main beam.
You can google a circuit diagram then it's fairly straight forward.
If you need help and are close enough I'll help
Last edited:
