frog hopper
Well-Known Member
1988 2.4 VM. The old girl is getting more and more difficult to start as the weather starts to get colder. As I have been used to 200Tdi's I may not know how to start the thing if that makes sense.
Turn key to activate glow plugs, wait until glow plug light goes out on dash and turn the key to activate starter motor, up to this point I have not touched the throttle, just depress the clutch pedal. If the temperature is down to about freezing it will take at least 6 or 7 seconds of cranking before she catches and fires up, is this right for this engine?
I have changed all the glowplugs, cleaned and greased with copperslip all electrical joints.
I put my multi meter onto the feed tag where it joins the glowplug connections, the earth probe onto the battery negative post, when plugs are activated I am getting between 10.7 and 11 volts, the batteries are past the first flush of youth but are "reasonable".
I have tried giving a double dose on the glowplugs but that doesn't seem to make any difference.
I had a good trawl through my Brooklands manual but it doesn't give much detail on the VM other than setting the "Cold Start Advance" (RTC5624) the recommended gap in the mechanism is 3-4mm, mine was at 5mm so reset it to 3.5mm, this has made no difference. To be honest I'm not sure the cold start is working, does anyone know how I can check this unit?
Sorry for the extra long post, just trying to include as much detail as possible.
Turn key to activate glow plugs, wait until glow plug light goes out on dash and turn the key to activate starter motor, up to this point I have not touched the throttle, just depress the clutch pedal. If the temperature is down to about freezing it will take at least 6 or 7 seconds of cranking before she catches and fires up, is this right for this engine?
I have changed all the glowplugs, cleaned and greased with copperslip all electrical joints.
I put my multi meter onto the feed tag where it joins the glowplug connections, the earth probe onto the battery negative post, when plugs are activated I am getting between 10.7 and 11 volts, the batteries are past the first flush of youth but are "reasonable".
I have tried giving a double dose on the glowplugs but that doesn't seem to make any difference.
I had a good trawl through my Brooklands manual but it doesn't give much detail on the VM other than setting the "Cold Start Advance" (RTC5624) the recommended gap in the mechanism is 3-4mm, mine was at 5mm so reset it to 3.5mm, this has made no difference. To be honest I'm not sure the cold start is working, does anyone know how I can check this unit?
Sorry for the extra long post, just trying to include as much detail as possible.