i have a slight misfire when reving me v8, it is very slight, but drives ok revs up ok. i know it can be loads of different reasons, i have changed plugs its had a service but i not changed the leads it dont use any water, no signs of head gasket or liners, just yet. lol. i dont know how old the leads r, has anyone had the some problem and is there a way of checking out what it could b and if its the leads which one?????
jt_armstrong
Well-Known Member
Wait until it gets dark and then open the hood and look at the leads for signs of arcing. You will need to look closely if the misfire is slight. Might be worth a new set of leads in any case. I replaced mine with OEM leads and it made a hell of a difference.
Last edited:
ISO 3808 is just the Standard they are made too....
I always thought they were menat to be 8mm, but I could be wrong....
If you have the cash, Magnecor make good leads....as do Bosch....
Lead changing is best done one at a time, and also route them carefully so they don't cross if you can help it, as a crossed lead can cause a crossfire between plugs....
I always thought they were menat to be 8mm, but I could be wrong....
If you have the cash, Magnecor make good leads....as do Bosch....
Lead changing is best done one at a time, and also route them carefully so they don't cross if you can help it, as a crossed lead can cause a crossfire between plugs....
jt_armstrong
Well-Known Member
Try these from island.... V8 HIGH PERFORMANCE HT LEAD SET 98-02 HLS103XP Island 4x4 - Specialists in Land Rover and Range Rover Parts and accessories for all models. UK and worldwide mail order..
When you change them do them one at a time. It is possible to get your hand round the back of the coil. It takes a few tries but after a while you will have lost sufficient skin to make your hands fit...
Now if you have LPG then that is a whole different world of pain..
jt_armstrong
Well-Known Member
Care to share the logic tree you are following that gets you from HT leads to camshaft in one step...
nice one mate that dus help alot, cus i all ready have lpg it will be a bugger to get at coil pack so i will take of manifold, as it looks easy anuff. is there any seals that i need to replace after takinging them off????
Last edited:
Care to share the logic tree you are following that gets you from HT leads to camshaft in one step...
well i thought i would check to see if that could be a problem i am trying to eliminate things, cus its dun 100 tho miles. not sure how long cam lasts. it is probably leads, but my luck no its not.lol
jt_armstrong
Well-Known Member
Those ate what I fitted to my '99. As far as I know they are the OEM.
jt_armstrong
Well-Known Member
Those are what I fitted to my '99. As far as I know they are the OEM.
Most Compression testers will have a Green Zone to indicate the optimum pressure....
What your interested in seeing is if there is a difference between readings in different cylinders....
Two adjacent low cylinders could indicate HGF betwwen the two cylinders....
If one reading is low, dribble a teaspoon of oil into the cylinder via the Spark Plug Hole, if the reading rises, could be worn piston rings, if it stays the same could be HGF of Valve seal or Valve Stem Seal.
What your interested in seeing is if there is a difference between readings in different cylinders....
Two adjacent low cylinders could indicate HGF betwwen the two cylinders....
If one reading is low, dribble a teaspoon of oil into the cylinder via the Spark Plug Hole, if the reading rises, could be worn piston rings, if it stays the same could be HGF of Valve seal or Valve Stem Seal.
