Mel botterfield
Member
morning all. I've got a set of landrover side steps to fit to my 2006 hse 5 door. Are the predrilled holes there or do I need to drill and tap new.
teddywood1
Well-Known Member
10 mm ones
Mel botterfield
Member
Do you mean riv nuts to accept a 6mm bolt with a 10 mm socket size?
Last edited:
teddywood1
Well-Known Member
yes
Mel botterfield
Member
Well, stripped all the brackets , applied rust treatment after removing them from the steps then painted with hamerite .Drilled out the old fixings as the bolts were rusted in. Fitted new riv nuts and refitted ro the steps using stainless bolts all round then mounted to the landy.
Looks good now.
Looks good now.
Mel botterfield
Member
New job today. Rear n/s widow cable snapped. Replaced with an eBay one. Perfect replacement but what a pig trying to wind the inner cables around the white nylon wheel. Working fine now though. Tried the other side rear and ping crunch. So ordered another kit.
I've discovered that removing all the internal screws on my inner-doors and tail-gate and then spraying a general maintaince oil aerosol through the screw holes helps prevent the mechanism failing in the first place.
